How to Inspect Used Drill Pipe Before You Buy

Used drill pipe can save real money, but only if you know what you are getting. A listing that says "used, 5-inch, G-105" tells you very little about remaining life. Here is what to ask for and what to check before you commit.

1. Start with the basics

Confirm the specs match your well program:

  • OD and nominal weight (for example 5" at 19.50 ppf)
  • Grade (E-75, X-95, G-105, S-135)
  • Length range (Range 2 is the usual length; mixed ranges complicate tripping)
  • Connection (NC-50, 4-1/2" IF, XH, FH, or a proprietary thread)

If a listing leaves any of these out, ask. Missing specs are a reason to slow down.

2. Ask for the inspection report

Used pipe should come with a third-party inspection report. Key points:

  • Standard and category. Reports usually reference an industry inspection standard such as DS-1, with a category number. Higher categories cover more tests.
  • Date. An old report on pipe that has since been moved or stored tells you less.
  • Traceability. Joint numbers or serials on the report should match the pipe.
  • Class results. Used pipe is sorted by remaining wall and defects into classes such as Premium and Class 2. Premium is the stricter class. Ask how many joints fell into each.

"Inspection upon sale" is not the same as inspected. If an inspection is offered at the time of sale, find out who pays and what category it will be.

3. Check the pipe body

  • Wall thickness. Remaining wall drives collapse and burst ratings. Ask for the minimum wall measured, not just an average.
  • Surface damage. Look for pitting, cuts, gouges and corrosion, especially near the upsets.
  • Straightness. Bent joints cause vibration and uneven wear.
  • Internal condition. If the pipe has internal plastic coating (IPC), ask about coating condition and whether the report covers it.

4. Check the tool joints

The tool joints are where most used pipe is rejected or downgraded.

  • Threads and shoulders. Look for galling, washouts, damaged shoulders and thread wear.
  • Tool joint OD and ID. Wear here limits make-up torque and affects tong space.
  • Hardbanding. Check how much is left and whether it is raised, worn flush or cracked. Ask where it is applied, box only or both ends.
  • Thread protectors. Clean, intact protectors are a good sign on stored pipe.

5. Ask for material documents

Mill test reports (MTRs) document chemistry and mechanical properties and are usually tied to heat or lot numbers. Not every used joint has them, but if you need documentation, ask before you buy, not after.

6. Ask about quantity and mix

  • How many joints are on hand, and are they one lot or several?
  • Do all joints share the same grade, range and connection?
  • Are some joints already pulled out as rejects?

Red flags

  • No inspection report, or one that cannot be matched to the pipe
  • "Premium" used as a marketing word with no class results behind it
  • Mixed grades or ranges in one lot with no joint breakdown
  • Stock photos instead of photos of the actual joints
  • Heavy tool joint wear with fresh paint over it

If you see any of these, ask for clarification in writing before you put down money.

A quick checklist

  • Specs match: OD, weight, grade, range, connection
  • Inspection report: standard, category, date, serial match
  • Class breakdown by joint count
  • Minimum remaining wall
  • Tool joint and thread condition
  • Hardbanding condition
  • MTRs, if required
  • Photos of the actual pipe

Next step

If you are sourcing pipe now, see what we have in stock: Drill Pipe, Heavy Weight Drill Pipe and Drill Collars. Call Genesis Oilfield Pipe & Supply at (800) 310-5990 with your specs and we will tell you what is available.